亚洲精品在线观看少妇,国产激情亚洲一区,国产人碰人摸人爱免费视频,久久国产精品一区二区,久久国产精品免费看,日韩欧美视频熟女,婷婷午夜电影在线观看,色婷婷国产麻豆精品,八年沉淀只做精品,国产在线视频专区,日韩欧美纯爱电视剧电影免费观看,亚洲国产日本免费观看,天堂亚洲欧美日韩一区二区,中文字幕有码系列在线观看,久久日韩精品一区,小明欧美精品视频在线观看,91av成人一区二区三区,欧美日韩亚洲综合在线一区二区,亚洲一区二区二三区日日骚,在线观看欧美一区二区三区精品,日本欧美黄色一级片,欧美av一区二区三区在线观看,91成人国产麻豆一区二区

Main reasons for steel structure reinforcement

The main reasons for steel structure reinforcement are as follows:

(1) Steel structure defects caused by planning or construction, such as insufficient weld length, excessive reinforcement cutting, excessive section weakening, etc.

(2) After the structure has been used for a long time, it has corrosion, abrasion and abnormal operation to varying degrees. It causes structural defects and seriously weakens the section of structural members.

(3) The change of process production conditions increases the load of the structure, and the original structure cannot be used to.

(4) The quality of steel used does not meet the requirements.

(5) Accidents and natural disasters seriously damaged the structure.

(6) The deformation and destruction of the structure are caused by the foundation subsidence.

Reinforcement principle of structure or component

(1) Reinforcing bars should be produced as little as possible without production, because the loss caused by stopping production is often several times or dozens of times of the cost of reinforcing bars. Whether to stop production and strengthen under load depends on the stress and strain state of the structure. When the internal stress of general members is less than 80% of the planned strength of steel, and the damage and deformation of members are not too serious, the non-stop reinforcement method can be used.

(2) The structural reinforcement scheme shall be easy to make, construct and inspect.

(3) Structural fabrication and assembly shall be carried out outside the production area as far as possible.

(4) High strength bolts or welding shall be used as the connecting reinforcement. When high-strength bolts are used for reinforcement, the bearing capacity of the weakened drilling section shall be checked; When welding reinforcement is selected, the stress of the original reinforcement caused by the actual load shall be better than 60% of the planned strength of the reinforcement, and the limit shall not exceed 80%, otherwise corresponding measures shall be taken before welding.